Adapting a Radix mp112 to a 2007 Tahoe, any special parts needed?
#1
Thinking about buying a used mp112 radix kit, just not sure what special parts if any i may need in order to fit it to my 2007 Tahoe. As far as the blower goes, is it a direct swap over? I know sometimes the valley covers have to be changed but wasnt sure if that was specific to the TVS blowers or these as well. Any and all information is really appreciated. Thanks!
Also, with the 2007, is a new fuel pump needed or will the stock pump be ok?
Also, with the 2007, is a new fuel pump needed or will the stock pump be ok?
#3
Thanks for the info! I am worried your 2300 may be too much for my simple daily driver Tahoe. LOL.
I am guessing this is valley cover i will need?
Magnuson (Magna Charger) LS-1 Valley Cover MagnaCharger LS1 Valley Cover [M-31-14-59-034] - $110.00 : SuperchargersOnline, Worlds largest Supercharger Resource. Get Serious About Power
I am guessing this is valley cover i will need?
Magnuson (Magna Charger) LS-1 Valley Cover MagnaCharger LS1 Valley Cover [M-31-14-59-034] - $110.00 : SuperchargersOnline, Worlds largest Supercharger Resource. Get Serious About Power
#4
#5
If the truck is factory flex fuel, the pump should be fine for 500hp give or take on pump gas. If not, then you'll need a new pump, same with injectors the stockers won't support much if any boost. I'd suggest 50-60lb/hr.
#6
Yep, no flex fuel on my Tahoe. I knew the injectors needed to be replaced. Wasnt sure if the pump needed to be or not.
I feel like i am going to eventually find that there are a lot of odds and ends that will be needed to get this squared away.
I feel like i am going to eventually find that there are a lot of odds and ends that will be needed to get this squared away.


