I have my Allison xb2002 up for sale. I recently purchased and haven't decided yet if boating is for me. So I'm listing to see if there is any interest. Engine hours are unknown, compression check came out great across all cylinders. Motor is a '95 Merc 150hp, oil injection delete kit. 28 pitch stainless steel prop. Factory Allison jack plate, Allison dual steering cables with hot foot. Boat shows signs of sunfade, few nics here and there with one problem spot in the gel coat. Had a troller motor on the front but was removed, so the holes are still there. Has a blinker style trim switch installed on the steering hub. Boat has Tach, water pressure, water temp, speedo, and fuel level gauge. The tach and fuel level gauge work great, water pressure gauge is a little off, the other gauges are inoperable. I have the orignal Allison trailer, still in fair condition. Boat is in overall very nice condition, and these hulls are a lifetime hull, being complete fiberglass hull there is no wood to rot. Contact me with more questions and I will do my best to answer. Boat is still registered under the Alabama registration, but is located in Mississippi. Price is $10,000 obo possible trade...

 

its got a 2.5cal on a 150?

 

It's a 2.5 liter 150hp V-6, but it is a drag cowl and not a drag motor.

 

The motors that cowl came from the factory on were 265's, just why I was asking, I know the allison's with the 265's were 95-100mph boats

 

Yeah, it's just a cowl swap. Though this set up tops at 75mph, could do better with a lower cone unit and better prop.

 

Gone.