Patriot Dual Springs and LS2 intake
04-01-2009, 06:42 PM
#1
On The Tree
Thread Starter
iTrader: (70)
Join Date: Jun 2008
Location: Jacksonville, Florida
Posts: 150
Likes: 0
Received 0 Likes
on
0 Posts
Patriot Dual Springs and LS2 intake
I have a set of Patriot Dual Springs for sale. Come with everything you need to install. Springs, super7 locks, titanium retainers, bases, and valve seals. These are new still sealed in the plastic. I ordered a set after I broke one of Comp cams "NEW DESIGN" beehive springs. When ordering I ordered two set by mistake and didn't notice until the charge went through. So I am selling the second set. SOLD
Second have a LS2 intake only for sale. Got this off a friends Vette after it caught fire. It had a little spot get melted on the rear driver side. you can see it in the second picture. Had it tested for leaks it had none. So cleaned it and painted it. Where the vacum hose connects to at the TB is also broke, was goin to plug it but never got around to it. Couldn't get a clear picture of it but you can see where it was in the first picture. I came across another LS2 intake that was ported and tapped for direct port N20. So no longer need this one. $150.00 shipped.
Paypal only. Sorry for this but have had problems in the past with money orders.
Second have a LS2 intake only for sale. Got this off a friends Vette after it caught fire. It had a little spot get melted on the rear driver side. you can see it in the second picture. Had it tested for leaks it had none. So cleaned it and painted it. Where the vacum hose connects to at the TB is also broke, was goin to plug it but never got around to it. Couldn't get a clear picture of it but you can see where it was in the first picture. I came across another LS2 intake that was ported and tapped for direct port N20. So no longer need this one. $150.00 shipped.
Paypal only. Sorry for this but have had problems in the past with money orders.
Last edited by RADO_4U2NV; 04-02-2009 at 04:24 PM.
04-01-2009, 07:09 PM
#4
On The Tree
Thread Starter
iTrader: (70)
Join Date: Jun 2008
Location: Jacksonville, Florida
Posts: 150
Likes: 0
Received 0 Likes
on
0 Posts
To be honest I never had it on mine. That is what it was goin on. I have read the it gives better resonse over the trunk intake. You may lose some tourqe down low but will gain in higher rpms. Long runners low end short runners high end. I did notice after looking at the truck intake and the LS2 intake the LS2 is alot bigger inside and it hase the 90mm inlet compared to the trucks small inlet.
Trending Topics
Thread
Thread Starter
Forum
Replies
Last Post
CashDudeHomie
INTERNAL ENGINE MODIFICATIONS
10
08-03-2015 10:58 AM
07NBSChevy
GM Engine & Exhaust Performance
20
07-08-2015 07:27 PM
