To get around 2-3 inches all the way around...

And on my 4x4 ive heaRD to even out the front there is torsian bAr extenders?


Lets here some advice please.

 

I think you can get Ford keys for 2" in the front. Alot of people have done that.

 

You can crank up the torsion bars using the indexers, or "keys" as some people call them. This will get you 1"-2" in the front, which will level it out w/ the rear. Some people use the Ford keys in the front, with a 3" block in the back, and get 2-3" in the front. Either route will wear things out in the front a little faster than it would if it was stock. A bodylift will get you 3" all the way around, and has no affect on the mechanicals. HTH.

 

Hmmm where can i get these Keys?

 

a few companies make 2" torsion keys. Pretty cheap way to drop a 4-by.

for the rear, get 2" shackles

 

i want to lift not raise.

 

idiot i am i want to lift it no lower. Where is the best place to get the keys?

 

Right at the Ford dealer...can't remember the part # off hand, maybe someone else will. I'd try cranking the factory keys first, you might be happy w/ the height you get out of them.

 

Found the part # for ya, it's XL3Z5B328CA...about $20 a piece.

 

thanks man!