Rifle stock cut down rework
11-26-2013, 07:03 AM
#1
TECH Enthusiast
Thread Starter
iTrader: (7)
Join Date: Nov 2011
Location: Douglasville, Ga
Posts: 507
Likes: 0
Received 0 Likes
on
0 Posts
Rifle stock cut down rework
This is a project I'm doing for a customer. I'm trying to make it look as factory as I can with out it looking like it was cut down
11-26-2013, 08:07 AM
#4
TECH Enthusiast
Thread Starter
iTrader: (7)
Join Date: Nov 2011
Location: Douglasville, Ga
Posts: 507
Likes: 0
Received 0 Likes
on
0 Posts
its an .308 Winchester in a ruger. I think its an 18 inch barrel (have not measured it). I bet it had a little punch to it being so light and short. its a nice carry/scout rifle.
12-03-2013, 08:37 AM
#5
TECH Enthusiast
Thread Starter
iTrader: (7)
Join Date: Nov 2011
Location: Douglasville, Ga
Posts: 507
Likes: 0
Received 0 Likes
on
0 Posts
I got to work on this stock a little more,I opened the channel up for some extra room for the bedding and to center the barrel up in the stock. Next is to add the quick connect swivel to the forearm and then pillar and bed the action and barrel channel. After that is complete then to the finish.
Trending Topics
Thread
Thread Starter
Forum
Replies
Last Post
BennyB
GM Parts Classifieds
15
08-01-2015 08:48 AM