Flaking comp cam lobes
5 Attachment(s)
Not sure where to post this up on . . . custom cam that was in a FBO 08 5.3
This was in a low mile 5.3 with TSP heads, LS7 lifters. Had a few dyno pulls, few trips at the track, mostly driven to work in 20 minute trips. got a hold of comp this morning . . . I'll post up on what happens. This is my 4th cam of the year to see something like this. There was no noises or chattering going on. Cam was pulled to change and go to a smaller cam. Last picture shows a dip in the lobe on the lift side of the lobe Attachment 104285 Attachment 104286 Attachment 104287 Attachment 104288 Attachment 104289 |
Thanks Tootall, keep us posted. Sure would like an explanation for this crap, but I doubt I'll ever trust Comp again after all the QC problems these past few years.
|
Oh god this makes me nervous...
|
Damn...good job Comp. Glad I went with a Lunati cam my second time around. Keep us posted on what their explanation of this is. I'm sure they will blame it on install error or other parts causing the problem.
|
Originally Posted by Robert91RS
(Post 5204338)
Thanks Tootall, keep us posted. Sure would like an explanation for this crap, but I doubt I'll ever trust Comp again after all the QC problems these past few years.
Originally Posted by Vortec350ss
(Post 5204344)
Oh god this makes me nervous...
Originally Posted by zachm89
(Post 5204375)
Damn...good job Comp. Glad I went with a Lunati cam my second time around. Keep us posted on what their explanation of this is. I'm sure they will blame it on install error or other parts causing the problem.
|
dont forget about howards.
|
Originally Posted by TXsilverado
(Post 5204385)
dont forget about howards.
|
1 Attachment(s)
Here's another cam that I was talking about. This cam out of my truck after the theft recovery. There's considerable more mileage on this one, but it shows the same pitting and flaking on the cam. This one was reground, but it was at my cost.
This cam was a TSP Torquer V2, LQ4 with L92 heads Attachment 104276 |
i would take it to a machine shop and have the hardness checked..
|
what about Cam Motion. Last time I talked to Geoff at EPS he had started using them.
|
All times are GMT -5. The time now is 07:12 AM. |
© 2024 MH Sub I, LLC dba Internet Brands