Hivelocit

iTrader: (7)

Was looking around online researching lq4 builds and ran into this neat little trick. Most who have rebuilt their engines, I am sure, have ran into an issue with holding the Crankshaft in-place. Have seen a lot of FP holders, but most are overpriced. Here is a method I found on an engine building website I am going to try, instead of using the old screwdriver method. This might already be listed but though I would post it any ways.

Atomic

iTrader: (42)

Well thats dandy...

Hivelocit

iTrader: (7)

Yeah I imagine a little fab work is certainly at hand, but easy to do! Thats not a typical engine stand though. Going to play around and will post a pic when I am done for something on a typical stand. Just for the hell of it...