Engine/Trans/T-Case Swap into RCSB
 

I am in the process of changing over the engine, trans, and t-case on the regular cab.

New set up will be a 6.0, 112, 4l80 with shift kit, 32 spline NP-246 t-case. A lot of little things as well, 34" radiator, 2005 efans, trucool trans cooler, hd valance, etc.

I have a full weekend into it so far... I have been cleaning and painting things as I go, so it is taking me a bit longer that just swapping parts.

Here is a pic when I was debating whether I should I do this or not... haha
http://i19.photobucket.com/albums/b1...beforeswap.jpg
http://i19.photobucket.com/albums/b1...beforeswap.jpg

Motor half way out:

http://i19.photobucket.com/albums/b1...llprogress.jpg

And then out:

http://i19.photobucket.com/albums/b1...ndtransout.jpg

6.0 ready to go in:

http://i19.photobucket.com/albums/b1...Cab/engine.jpg

Starting to install the accessories:

http://i19.photobucket.com/albums/b1.../60firstin.jpg

http://i19.photobucket.com/albums/b1...yinstalled.jpg

Looking good J. When you gonna finish up?

man that was fast, subscribe good work

Hope to get most of it wrapped up this weekend... probably gonna be a long one! lol
Thanks man - it was a couple late nights for sure.

Did you drop that in with the blower on?

Looking good!

Yes I did.... Turned the motor sideways, dropped it in, and then turned it back and slid it back.

Thanks!

that was fast work.. subscribed, i wanna see how it turns out!!

bad ass man.. good work