Originally Posted by lownslo06

haha you will never catch me

Originally Posted by Blown06

Got more pictures from the crew over at madman's. This is the new trans x-member. One of the main reasons I wanted them to do that was that I had a bad feeling that the motor was not in the truck level after I did the 4l80 conversion. Brian told me that had to lift the back of the motor about 3*. They also integrated a drive shaft safety loop. Looks like I gained some ground clearance and lost a little weight too.

Looks good guys, I appreciate the photo updates and excellent customer service.

Originally Posted by MADMAN

I don't know if you can tell from the picture, but I made that crossmember such a way that you can run your exhaust above it on either side of the bend. Just a little thought to chew on for ya.

Originally Posted by Low_LSX

I wish you could make more of these. I'd be inline for one, its a total improvement over the stock one. Could you get more of them made if needed?

Originally Posted by mad_steve

I have a file saved for the main cross-member, but we would need the truck here to actually build the trans. mount and DS safety loop.