New exhaust vids... Idle, Rev, cruising and 20-70 punch
 

Sorry for the crappy vids, but my phone sucks... I just got throw tossing in a retune so i figured i would snap some vids... The tune is pretty conservative, low timing and low shift point, not to mention it is hotter than satan's ballsack right now... :(

Idle vid, currently idling at 750. For the vaginal sized cam i am running it talks a little bit :)


http://i27.photobucket.com/albums/c1...xhaustIdle.jpg


Little rev, sorry can't get nuts because i don't want to annoy neighbors, BTW the door is open

http://i27.photobucket.com/albums/c1...ustIdleRev.jpg


half throttle take off then cruise... You can see in the vid where i set the cruise control... Very very quiet at cruising

http://i27.photobucket.com/albums/c1...lfThrottle.jpg

short 20-70 run, still running low timing and it was 100*... I am only shifting at 6100 right now...

http://i27.photobucket.com/albums/c1...hrottle-01.jpg


The truck is still slow, but gradually getting faster... One of these days i will be one of the cool guys... :(

Sounds great. When are you planning to get track times for a relative 60-80 comparison?

Probably the fall it is just toooo damn hot. I would be a sweaty mofo after putting on my slicks. Then not be able to use the AC the whole time would freaking suck.

Sounds awesome!

Thanks man, but i need a bigger cam....

It's never ending huh lol.

Every time I get one mod my mind is racing to the next one I need to find out how to get

yep it is endless.... i might just buy one to tide me over for a little since the 4-Link will not get completed until Christmas... I gotta feed the mod-monster....

sounds great bro and what size cam u wanna go with next time?

Comp cam 226/230 .605/.609 112+4 That is on the new Comp LXL lobes... Similar to the EPS grind...

or

230/234 .609/.612 112+4

That 20-70 sounds really good!!

If youre going to go for another cam might as well make it worth your while and get the big one. A welder is on my "to-buy" list for next year. I want to be cool like you :jest:

I too would like a welder but I don't think i have enough projects to justify one. Plus I don't know how to weld... LOL

My welder needs some work :(... I need to get a new regulator, the orginal one died and i bought a harbor freight one, and it is just not the same... my welder might be dying on me which would suck... it does flux core just fine, but when i try to weld with gas it just does not penetrate....

I am not the best welder but my shit penetrates it just not super pretty like other goes...