4l80e harness swap to 4l60e possible?
#1
4l80e harness swap to 4l60e possible?
Good morning PT,
Few questions i have recently installed a 2006 5.3l/60e with matching PCM into a 84C10 ok.
But the wiring harness i used was out of a 2006 2500 lq4/80e, the truck turns on turnkey no problems and can even drive up/down my backyard. But the transmission isnt right, i know the 60e harness has different pins you usually switch positions when doing a 80e(i.e. Pins 22/23)swap.
So my question is, do i do the opposite since i have the 80e harness swaping to a 60e tranny? Or can i just get it tuned?
Thank you,
GOD BLESS
Few questions i have recently installed a 2006 5.3l/60e with matching PCM into a 84C10 ok.
But the wiring harness i used was out of a 2006 2500 lq4/80e, the truck turns on turnkey no problems and can even drive up/down my backyard. But the transmission isnt right, i know the 60e harness has different pins you usually switch positions when doing a 80e(i.e. Pins 22/23)swap.
So my question is, do i do the opposite since i have the 80e harness swaping to a 60e tranny? Or can i just get it tuned?
Thank you,
GOD BLESS
#3
Good morning PT,
Few questions i have recently installed a 2006 5.3l/60e with matching PCM into a 84C10 ok.
But the wiring harness i used was out of a 2006 2500 lq4/80e, the truck turns on turnkey no problems and can even drive up/down my backyard. But the transmission isnt right, i know the 60e harness has different pins you usually switch positions when doing a 80e(i.e. Pins 22/23)swap.
So my question is, do i do the opposite since i have the 80e harness swaping to a 60e tranny? Or can i just get it tuned?
Thank you,
GOD BLESS
Few questions i have recently installed a 2006 5.3l/60e with matching PCM into a 84C10 ok.
But the wiring harness i used was out of a 2006 2500 lq4/80e, the truck turns on turnkey no problems and can even drive up/down my backyard. But the transmission isnt right, i know the 60e harness has different pins you usually switch positions when doing a 80e(i.e. Pins 22/23)swap.
So my question is, do i do the opposite since i have the 80e harness swaping to a 60e tranny? Or can i just get it tuned?
Thank you,
GOD BLESS
That's what I would do, it would be reverse of doing a 60e to 80e swap.
Thread
Thread Starter
Forum
Replies
Last Post
lycominghunter
GM Drivetrain & Suspension
5
07-29-2015 04:24 PM
GreyChevy
Tuning, Diagnostics, Electronics, and Wiring
1
07-07-2015 08:57 PM
Nimoryan
GMT 800 & Older GM General Discussion
0
07-05-2015 03:50 PM