4.8l 4wd manual trans
05-10-2019, 07:15 PM
#11
not with mine - i have the early style where the quick-connect is at the slave & half the line is smaller ID plastic.
that potentially applies to the later lines (like yours, i believe) where the line is full braided & the quick-connect is at the master. at least with the f-bodies, you could drill through the restrictor (i think the roll pin end) to increase the fluid flow.
that potentially applies to the later lines (like yours, i believe) where the line is full braided & the quick-connect is at the master. at least with the f-bodies, you could drill through the restrictor (i think the roll pin end) to increase the fluid flow.
Thread
Thread Starter
Forum
Replies
Last Post
Tipsz
GMT 800 & Older GM General Discussion
15
03-16-2005 02:17 AM