Dyno 2.0 coming soon - any guesses?
#19
Moderator
iTrader: (20)
I overestimated the heads... but its still pulling. 5800 is not near enough RPM for that cam. Feed it a tad more timing as it continues to rev and it will make more steam. I would start adding in small increments at 5400 or so.
Also what is the MAP reading as you get up there in the revs. A little bit of vacuum can kill top end power too.
Also what is the MAP reading as you get up there in the revs. A little bit of vacuum can kill top end power too.