2005 Silverado

iTrader: (19)

Its out of a 07 Chevy with 26k on the clock. Tech buddy says it got into water and has a bent rod but was drove in. He dropped it off by the shop today its a long block with pan and covers (he is letting my check out fully before i pay and a guy i work with has a magnaflux so i can check the block for cracks), pulled the heads, NO rust at all. Heads have alot of carbon build up, but look great otherwise. Tomorrow i am going to get the pan and covers off (and get some pictures so i dont get banned for lack of proof).

So does 350 bucks for it sound ok?

Dustin

dlt76028

iTrader: (13)

is that the 367hp vortec max?

built408

iTrader: (10)

probably just a bent rod. 350 sounds like a smokin deal to me.

2005 Silverado

iTrader: (19)

No idea. I know nothing about the Gen IV motors, like wtf is up with the reluctor wheel **** haha, and no knock sensors under the intake, they are on the side WTF

I am sure its a bent rod, will spin by hand then just stop. But can be turned all the way around. I was giggling like a school girl when i got the heads off. I hope to giggle again tomorrow.

Dustin

GMCtrk

iTrader: (27)

The heads alone are worth more than that

1slow01Z71

iTrader: (36)

If you dont want it Ill have my dad go pick it up for me, I could use a few more motors to stockpile in my garage

Mangled03gmc

iTrader: (95)

And you havn't got it WHY???????????????????????????????????????? for the love of hittler, DO IT

2005 Silverado

iTrader: (19)

I have it...and only 1 ? was needed. I am going to pay him tomorrow. Who knows of some good rods and pistons and gasket kits haha.

I gave myself 2 options, if block is good, hone and get the stuff for a stockish rebuild, or go radical haha.

Dustin

thunder550

iTrader: (70)

You putting it in your truck?

2005 Silverado

iTrader: (19)

After a little work that would be the plan. But it could be a nice coffee table peice.

I just have to see how the block and everything looks after i get the rods and crank out of it.

Dustin