Well I think it's time to just sell the intake as all it's doing now is sitting. I had every intention of putting it on til I made the power I made on my stock one which is already setup with aftermarket rails that won't work on the Edelbrock intake. This intake is actually the LS1 version (P/N 7139)that has been drilled out to accept the LS2 TB. The only difference between this one and the LS2 version (P/N 7140) is the LS2 has the o-ring groove cut into the manifold and this one will use a gasket and the obvious bolt pattern. The top 2 holes of the TB use the factory holes the bottom 2 have been drilled through and now use a nut/bolt to hold it down.

Price is: SOLD (I paid that which I thought was a good price so I figure I'll pass it on. Cheapest place I've found is SDCE for $419 (7139).

 

interested. Give me best price shipped to 77539.

 

Ttt...

 

SOLD

Thanks PT.net