parks450

iTrader: (18)

Anyone?

parks450

iTrader: (18)

Slowly getting there, just got my transfer case input from time2kill and dropped it off a shop to have swapped, then I can get my driveshafts measured. Have a little bit of the wiring harness to loom since no one local sells 1.5" wire loom. V bands on the headers turned out really good, will help a lot with having to remove the crossover pipe, hopefully I never need to.

parks450

iTrader: (18)

Well after having some oil pressure issues finally got it back together and done. Tweaking tuning now, runs pretty good. Not much interest from people here lol but for those curious a few finished pics.







Anyone have an idea what this plug is also? Passenger side, firewall. Thinking ac something.

01FormulaTA

iTrader: (16)

Nice project! Why did you decide to go with the LS3 intake vs L92 truck intake? What all accessories did you have to swap out to make the LS3 intake work?

Choda

iTrader: (1)

Great project and progress.

Wolftrk99

iTrader: (5)

Looks good!!!

stroker87

iTrader: (6)

what did you have to do to the wiring to get the 6.2 to work? i got a 6.2 for my 2004 rcsb but havent really found any thing out about the cam sensor, timing wheel and so on

looks good!

GMCtrk

iTrader: (27)

Hydroboost was swapped on this truck, correct? I thought none of the 1500 trucks came with hydroboost from the factory.

heeter_33

Nice build. Have a build thread for your s10 anywhere?

parks450

iTrader: (18)

Had a buddy who had one for cheap, so just decided to throw it on. Only had to get the dirty dingo idler relocation pulley and trim a small piece off the alt bracket by the intake.