how much can i bore out a 6.0 iron block?
#1
On The Tree
Thread Starter
iTrader: (4)
Join Date: Feb 2010
Location: Los Angeles CA
Posts: 109
Likes: 0
Received 0 Likes
on
0 Posts
how much can i bore out a 6.0 iron block?
lets see.. i have a 2 spare motors.. 1 lq4 and one is a lq9..
i have one lq4 in my truck right now
so i want to bore this one out.. i heard 370cc = .30 over ?
is that all i can go over?
forged pistons and rods.. keep crank stock and boost it??
feedback much appreciated
thanks..
i have one lq4 in my truck right now
so i want to bore this one out.. i heard 370cc = .30 over ?
is that all i can go over?
forged pistons and rods.. keep crank stock and boost it??
feedback much appreciated
thanks..
#7
9 Second Truck Club
iTrader: (16)
You must sonic test to know for sure. I have seen a few over .300" thick that would easly take a +.100 bore and a couple that are less than .200" thick. Most are around .225-.250" thick on the thrust but get down to .100 between the cyls. Id only go +.005" unless testing.