Ok I got a P0332 rear bank knock sensor code.. I went and repalced both the sensor and harness and put everything back together and still the light stayed on.. tried to disconnect the battery for 15 mins and still on.. Truck runs like crap on take off still.. Do I need to take it and to the dealer and get them to reset it:confused: I ohm'd out the sensor and got 90.2 on both and also ohm out the wire just make sure and everything is working perfect.. Even the main harness from the computer all checked out good. Any ideas??

Have the code cleared, should take care of it.

Aight thanks I am gonna do that tomorrow and see if that works

Are you sure the ohm reading was 90.2? IIRC it should be a lot higher than that, like 10k ohms or 1k, can't remember which. I think 10k.

well the front one is good so both were showing the same reading all around so the rear one must be working properly

Hmm ok.

Aight got my code cleared and that fixed my prob.. Thanks

Good deal :)