I have a 2000 r/t and wanna drop it 3/4. Was wondering if a regular dakota drop would work. seen on a couple of sites that some dont fit. Any help; would be great. thanks guys

they should work with blocks in the rear and springs in the frt.

i think that will be too much. dropped mine 2/3 and that looks good. well anything is better than the factory stance. u know the ass end is in the air

R/T dakota's are already an inch lower all the way around so if you buy front springs you need to make sure that you are not buying regular dakota drop springs

i had 2 Dakota R/T's...my second one i put a 2/3 drop on it and it looked pretty slammed, it was very very nice looking though, then i totalled a week later...i think 3/4 may be a bit much...its a sports truck so it needs to be close to the ground but not on it...anyway, post pics whenever you do it...i still miss my R/T's

i know it's been awhile but if your still debating check mine out. http://www.ls1tech.com/forums/vehicles-sale-non-lsx-powered/1039612-dakota-v8-rc-5-speed-trade-lsx-car.html

it's dropped 2-4 but it's non r/t

If your gonna do this do it right

http://www.streetbeatcustoms.com/2001/Dodge/Dakota/Suspension/

get the leafs not blocks and get the front springs...makes sure on the front springs you order for the v8 not v6 model

this is the setup i have. u wont be dissapointed.