I got the autometer electric fuel pressure gauge and went to put it in today...I noticed the little access hole that was plugged on the driver side fuel rail... Simple enough installation right? Wrong...Got the three pillar pod setup (broke my boost gauge, need to buy another one...i just dropped it and now it reads +20psi...)

Anyways, I went to screw in the sending unit directly to the fuel rail and it doesnt line up! The coil pack bracket is in the way, it wont allow the sending unit to clear to line up straight...great...so now what? Someone told me I will have to chase down a braided fuel line and adapter and remotely mount it? WTF? all the small stuff killing my time here!

Anyone who has a clear quick solution for me would be appreciated. If you have done the remote mount on a radix, also please tell what parts i need and where to get them. I've been to summit 3 times in the last week and dont want to drive down there again tomorrow.

Thanks.

 

All I did was take the coil bracket off , and grind clearance with a die grinder.
Ron

 

Done...bought an attachment for my drill and grinded in clearance. That was a PITA...seriously...