The fit and finish is nice, exactly what I would expect from a company like Dyna Tech! Check with your board sponsors to order yours!

 

Hmm, how will i know if mine are the new revised version?

 

if you just ordered them, more than likely they are.

 

Well, i ordered them from a company who had them in stock and were trying liquidate their inventory of dynamax. When were these new ones released?

Also any word on my blower and the thermostat?

 

Alright, i now see what the differance. The second tube on the drivers side header is not looped upward then back down on the new revision.

 

Looks better! Dynatech swapped my older ones out that were still in the box for a set of the new revised ones. Plus they sent them off to be Jet-Hot coated for me before they send them back, for a charge of $250.00.
Dynatech's customer service is far superior than most!

Jim

 

Dont forget their product is superior too! You get what you pay for as always

 

Installed!

A few things I think are very important:

1) These headers have the best fit and finish that I have ever installed at the shop.

2) The new revision is the BEST thing they could have done for these headers.

3) They do flow ALOT better, I am down 2 psi of boost after the header/cat install

4) The exhaust note is deeper, more of a "big block" sound.

5) MAKE A NOTE OF THE PROPER GASKET ALIGNMENT BEFORE YOU BOLT ON THE HEADERS. Just take my word for it, and dont ask anymore than that

6) The customer service at DynaTech is top notch.

7) There is more power on the top end, BUTT dyno tells me that.

8) Check with your site sponsor and order them NOW.

9) There are ZERO issues with spark plug wires

 

I smell bigger pulley

 

Will they take trade ins for their old design since thats what I have? Would call them myself but they are closed ATM figured you might know BC.