Here are just a few pics of his install when I got done with it tonight. It is a HSW wet kit with a HSW Edge nitrous controller. It is a very nice kit and works great. The bottle is in the small toolbox in the bed, the nitrous solenoid is under the K&N filter, the fuel solenoid is under the intake cover, and the HSW edge controller is hidden from sight in the cab. I wired into the TPS wire on the PCM red connector pin #24 for the nitrous activation. Tach wire went to pin #10 on the red connector I also set his controller up to read the stock narrowband O2 and if it senses a lean condition it will cut the nitrous system off. Justin (onebadrubi) wanted to spray a 100 shot and program in a delay and progressive setup and also keep from spraying during the shifts so I set it up for a .3 sec delay from time of WOT, starts a 50% and progresses to 100% in 1.5 sec. The window switch is setup to kick the nitrous on at 3000 rpm's and shut it off at 5500, because his truck shifts at 5600 rpm's. The controller is a very nice piece and installation is very straight forward. While installing I had a few questions for Matt at Harris Speed Works and he was very helpful. I just wanted to let everyone know what a quality product they sell. I will try to get some better pics in a few days.

 

sounds like a nice set up. how is the SOTP feel versus before? or does the controller take the torque spike out and alot less noticeable?

 

We installed the nitrous kit the same time we did the controller setup. I do not know the difference from just a button to the controller. But I DO KNOw it adds a small bit of power when active

 

Oh and man does rhino79 know what he is doin. He is very intelligent.....ALOT MORE THEN ME, and this would nto have been possible without him.

Hope he puts up with me for the more mods to come so I become a steel hauler and beat hte wood hauler.....lol j/k

 

Good job guys!

Matt

 

Thanks for all the help Matt, your controller works great....I think the Wood Hauler might get one of your progressive controller's soon.