when i hit the button for the nitrous it stall like the motor has died and then it launches why is it doing that for and what can i do to fix the problem.

when i hit the button for the nitrous it stall like the motor has died and then it launches why is it doing that for and what can i do to fix the problem.

Do you have a purge system on the nitrous? Mine was doing it because of air in the lines and it going a little rich because of the instant burst of fuel and the hesitation of nitrous. It was instantly fixed with the purge.

could be a few things too much fuel, nitrous that needs to be purged, very low bottle temps which would wind up making you rich, etc..

What's your bottle pressure at
Do you have a purge
do you have your jets in the right sides

could be a few things too much fuel, nitrous that needs to be purged, very low bottle temps which would wind up making you rich, etc..

What's your bottle pressure at
Do you have a purge
do you have your jets in the right sides

the bottle presure was only at about 750 to 800 when i tried it i have not tried it since i put the bottle heater on it and yes i do have a purge

Are you sure your nitrous solenoid is firing?
Did you check your jets?

Was it working perfectly before then just simply started happening?

Are you sure your nitrous solenoid is firing?
Did you check your jets?

Was it working perfectly before then just simply started happening?
no just hooked it up a couple of weeks ago and only tried it a couple of times

make sure you don't have the nitrous jet on the fuel and the fuel jet on the nitrous

Also did you test the solenoids without any fuel or nitrous being hooked up to see if they fired correctly?