- Anyone have Perma Cool E-Fans??
- Fuel Filter
- Exhaust help
- 408 cam choice
- Help! Truck won't start after cam/spring/rocker swap!
- Taylor Thundervolts?
- Why can't i go faster?
- Cutout on and damb!!!
- Ported my MAF
- Anybody have a set of rocker arms in the houston area
- Heres hou the Magnaflow dual in / dual out sounds like.
- Any gain with a Fbody cam?
- efan switch
- Need Exhaust opinions
- Magnaflows installed - more performance, yet quieter than stock!
- Flat Spot
- I love my cam!!!
- What will it take to get in the mid 12's
- Got 'er done (warning 56K killer)
- pushrods for 5.3
- 2500 mile fuel pump test
- Motor/tranny is in...... Problem...
- How often do you guys change fuel filter?
- 05 efan Toggle Switch Help?
- I think I got Screwed big time! Help
- TPS code
- XR275HR on an 05 chevy??
- Vinci 1.8 rocker install attempt #2 = success!!
- 408 parts
- pacesetter question
- What's a good spark plug?Quick answer please
- starting problem help!!!
- 15lb pulley
- IF???? If you had a Radix and wanted to put a 6.0 under it, what parts???...
- Weakest points of the 5.3
- K&N 77 SERIES
- quaestion about exhaust I ordered
- define "mild headwork"
- Need an oil pressure sender!
- what will it run??
- N.williams t.b.
- What to expect from a 80MM TB
- Truck EGR History
- Poll: Pros and cons of LS1 and LQ9?
- help me choose a cam!!!!
- Some rough numbers for my new setup
- volant or aem
- ls1 pistons are they flat top??
- Exhuast for a V6?
- need help gutting y-pipe
- Granatelli coming out with new programmer.
- ls1 injectors on a 5.3
- Need more nut on low end
- Single or Dual Exhaust????
- another ? for the machanical challanged mind
- Just currious
- Original Prototype Silverado SS Motor
- help on 6.0L cam
- Almost time for some fun
- Yet more exhaust questions (sorry kinda long)
- 5.3 heads on 6.0
- Aftermarket Guage install Questions
- Springs & Retainer?
- Help! Truck wants to stall
- Running rich???
- How does this cam setup look?
- Why does this happen?
- Cammn' a 5.3
- goal
- How Much Damage???
- True Dual Exhaust
- Read a few things in Handell's LS1/LS6 book...
- This cam for a stock stall?
- Dyno numbers
- Hot Cam
- Torque Specs
- fans
- Well I finally did it
- DTC code help!
- Volant, BBK and Granatelli products on sale!
- What thermostat?
- stock cam specs for 99 5.3
- What is your oil pressure with your LS6 Oil Pump?
- cats
- Yes, Yet Another Exhaust Thread. lol.
- corsa question
- LQ9, LQ4 how to tell?
- How to wake up '93 TBI 350??
- Schrader valve fitting size on fuel crossover tube?
- What can running a 11.9:1 Air/Fuel ratio hurt in a short amount of time?
- Chevy 5.3 STS Turbo
- need help...truck starts up like crap
- New Exhaust Setup Done!! Clips Soon!
- magnaflow hurt low end?
- First time poster with some ?????s
- eagle stroked 5.3
- Wanting to put headers on my 4.8 Anyone got advice?
- 8.1L 3500 Radiator into a Silverado 1500 Truck?
- Dyno report, WFT???
- what 408 heads
- LQ4 with shaved heads
- What combo should I go with for the new engine?
- 6L help
- I want stainless headers..... but no one seems to make exactly what i want.
- Free MagnaFlow ... West Coast Members!
- Where to run wiring for triple A-Pillar pods?
- 4.8 pulleys and doing without a/c
- Times, with Wait For Me after 350 miles
- Everything (and I mean everything) you ever wanted to know about a Gen3
- 1.8 rocker arms.....
- Bought 05 RCSB 4.8, got some ?'s
- enough backpressure???
- Cold Air Intake ?
- FMS 6.0 Results
- heads
- LS2 90mm intake.....
- Whipple
- Stainless Works Custom Exhaust Video
- 65lb inj for LS2 fuel rail
- i didnt lose any power w/ ls1 heads
- Crank Exciter Ring?
- Wiring harness?
- Zero Oil Pressure!! HELP
- Got some questions.
- 383 stroker
- What The Heck!?
- Auto-RX flush solvent
- Electric Fans
- What causes a lifter to tick?
- So i got the beast dynoed....I'm impressed!!!!!
- Injector question
- Tuning issue forces cam change (w/Radix)
- 4.8 --> 6.0 questions
- Finally getting something done! Pacesetters installed...
- what are some effective, cheap engine mods for horsepower
- You guys have me worried (disappointed) by the cam swap I was going to do tomorrow
- Corsa Exhaust Group Purchase!!!
- Leaking valve cover gaskets
- 6.0 swap questions
- Let's talk mechanical causes for KR
- Performance before and after tune?
- 800HP 383ci w/Trans & Blower
- dual or single exhuast
- zl 402 ls2 based aluminum short block
- new charger
- Flexible Fuel Engine
- help in SA
- What to do
- 5.3 to 8.1 question
- ARP questions
- Pacesetter's for 4x4?
- Swapping from the weak '99 5.3L.......
- LS1 Comp Cam 228/225 .588/.569 112LSA
- e-fan harness
- 5.3 cammers w/ auto trans
- update
- SES light after Wait for me Tune
- Any word from wheel to wheel
- Let's talk 02 Sensor's
- Can you test lifters?
- E-fan problems
- Before Radix Dyno Results
- 6L weight ?
- Rough Idle?
- 6.0 & l80E swap. Will it bolt right up?
- Gawd Damn
- Which turbo Setup???
- throttle body spacer
- corsa exhaust question
- Best Filters?
- ASM or JBA headers?
- CAM Decision
- TB & MAF quick stupid question
- Quick Fan ?
- Cam gains with Radix
- Just finished installing '01 LS-6 cam (first impressions)
- Flwxplate ?? Soon please
- phantom misfire ?? HELP!!
- Cold Air Intake Question
- Electric Fan Retrofit
- late model big block discussion
- Dynatech Group Purchase
- One last question about the 228/225 112lsa cam
- removing rev limit and speed limit
- Correct Idle RPM
- Engine guys in here
- CAI Questions
- 80e conversion complete / need gears?
- about to swap in a 6.0(LQ9) + 4L65E in the silverado; quick questions
- LT's for 4.8
- Borla tips changes sound?
- Speedo/calibration Box
- LS6 manifold etc??
- need info on this cam
- WTF? Truck is faster with the A/C on?!
- Radix question
- Think I have decided on the cam for the 408 opinions?
- 5.3 pushrod length
- LS1 fan questions.
- Another Header Question
- Too much??
- Its finally been done.......
- 2000 tahoe motor swap
- put my fans on and got a noise
- Installing Headers on a vortec 350
- LS1 Fans installed...NO WORKY!
- AMW install w/RADIX question.
- Re-installing stock U/D pulley Question
- 5.3 pushrod length??
- 01 Suburban burning oil
- Anyone Have o2 Troubles w/LT's?
- Codes after gutting converters??
- Exhaust is too raspy...need recommendations
- Recipe 2 B Quick off the line.
- Help me rev to 7200
- Horsepower/ TQ rating
- 01 tahoe engine removal
- need stock 6.0 (LQ9) tune in my PCM ASAP
- Last question...I HOPE!!
- Which ones have EGR?
- Whats easier
- Question on pacesetter longtubes
- hooker aero chamber
- BMF H2 getting it done!
- ASM's will fit a 4x4 correct
- Straight Exhaust
- is there too much lift in this cam?
- Mega install underway
- 6.0 throttle body
- raising redline
- Good performance oil??
- where does your truck idle?
- Is something just wrong with my tach.???
- A/C drip on Pacesetters??
- Need Advice On Installing Headers
- Pacesetter LT's and ORY = 2/10ths and 2mph
- price on a 6.0
- 5.7 heads to a 5.3 motor
- SuperMaxx Long Tube Headers On Sale!
- exhaust cut-out
- headers for 5.7
- Question About Headers Install
- Question About Installing Headers
- got the aero chamber on
- Aem Cai
- new lq9 in: wont start. wont turn over
- anyone know how to jump relays and bypass VATS system?
- How many older trucks are on here?
- 5.3 no cats/no muffler
- Cam is installed
|
View Full Version : GM Engine & Exhaust Performance Pages :
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
[78]
79
80
81
82
83
84
85
86
87
88
89
90
91
92
93
94
95
96
97
98
99
100
101
102
103
104
105
106
107
108
109
110
111
112
113
114
115
116
117
118
119
120
121
122
123
124
125
126
127
128
129
130
131
|
|
vBulletin® v3.7.4, Copyright ©2000-2010, Jelsoft Enterprises Ltd.