- Torq Thrust ST
- JBA Headers?
- ASM PASSENGER SIDE INSTALL>>>HELP PLEASE TRANNY FLUID LINES IN THE WAY
- Long tubes are in...
- Knockin on 13's Door
- Question: turning a SBRC v6 into a v8, whats it take?
- The total cost to swap to a 5.7 or 6.0 shortblock?
- Ported throttle body issues.
- 99-05 Y-pipe question
- Street slicks
- SC's Vortec or Magna???
- What muffler to choose?
- 4.8 silverado swap for 6.0
- truck running horrible(rich?) after ASM header install
- Bumpstick is in...
- Does anyone know what these Codes are??
- 4l60E 02 Tahoe Shift Kit or not w/Radix?
- Finally in the 12's
- What Radix pulley for my set up?
- Gears are in...
- PORN_1's Broken truck (Video inside)
- Can trucks use Corvette rear sensors up front?
- Boost ?
- LS1 into 93 Chev
- Need Exhaust Help with 02 6.0L...
- 300 hp 4.8 no power adder
- Another new guy looking for help
- Built Motor?
- Thermostat question
- TTP Dyno Day results
- best way to clean O2 sensor?
- DTC Codes
- Long Tubes
- What is needed to make the 14's?
- 6.0L LQ9 Oil cooler block off?
- Injector size on the Lq9 in the SS
- Denso Plugs
- question about electic fans
- Which Roller Rockers & How Difficult?
- Hooking up
- found some e-fans for $100
- Procharger ????s
- Help me with a cam for my truck
- Ram Air for 03-05 Silverados...Pics
- Are my dyno numbers good or bad? need opinions
- LS1 and no money
- Anyone use efi live?
- Went to the Track Today.....
- 90 mm tb
- Radix kit pricing... where to buy?
- 05 Chevy 1500 trans question...
- My 6.0..what can it become?
- Ordered ET Streets
- Why are my Dyno Numbers so Bad?
- Where can I get speedo recalibrated for '05 3/4T Duramax?
- Need some info on mods for my 5.3
- what brand / models do u use on ur tune-ups 5.3L
- Intakes for 01 dodge ram..looking for
- 4.8 to 6.0l swap.. HPtuners info required.
- Cams
- Pulleys for magna charger.
- burnt rubber smell??
- LTs vs MPG
- First time to the track 11.2 @ 125
- 10% off all headers and related products!
- Patriot performance cam
- new guy w/ a couple questions
- radix 5.3 or h/c 6.0
- questions on the lq9
- 6.0 questions?
- Porting 4.8 heads?
- Homemade CAI
- Suggestions...MAF sensor is maxing out above 5100 rpms!
- Silverado SS problem with Silenoid Sticking Open
- change spark plugs or not?-after running rich for about 100 miles
- need powerdyne help/info
- ARE 423 *Pictures*
- PAG oil----where the hell does it go in the condensor?
- Y-pipe diameter
- Any benifits in going with a custom 3" Y pipe?
- question about nelson fan harness?
- veter question again?
- 230/236.591/.601 110LSA Cam
- Track video of 2bseen's 11.83
- muffler?
- What cam for 370 ci?
- misfire
- new noise with ASM headers-need some help
- Home made CAI
- The 4.8L Lives Again!!!
- Has anyone used 27" ET Streets?
- Turbo guys how are you launching?
- Is Gibson cat-back really that bad?
- Corsa Exhaust for 5.3L?
- FS: Crane/VHP PowerMax Tuner
- Question about twins for my 5.3
- ATTN: Positive displacement Supercharger guys
- n2o or Magna
- Engine surging at part throttle-need help diagnosing
- Will I benefit with meth injection for towing??
- Need a fast answer!!
- Air Filter Question
- High Oil Pressure
- 6.0 stock rod strength.
- predator mph shutoff ?
- Typical EGT's for stock and blown?
- New Guy
- New Guy
- 5.3L heads
- EGR Delete, now SES light
- My Motor Broke !!
- Tips on Spring Start Up?
- Drag Wheel Pics
- Longtube Headers for 2001 chevy 5.3
- Where should I start?
- LS6 Cam?
- kaaaabooooommmm!!
- Well, they came in......
- What exhaust (with long tubes)?
- Dual Exhaust Awesome!
- Cam Question for 6.0l swap
- STS Install Problem - Oil Feed
- Braided Stainless Hoses
- stock 1/4 mile times 5.3 reg. cab
- Which converter?
- We talk alot at work
- Hotcam?
- Props to Nelson
- safety stuff
- heads to lower compression??
- Can you swap out head-bolts......
- exhaust pics
- going to need heads for a 4.8- got a few questions
- Volant CAI ?'s
- Front or remote mount turbo?
- AS&M Headers
- How high can you safely rev an '04 4.8L?
- Manuals
- Thorleys
- Crank pulley pin for Radix install
- Labor cost for motor swap?
- Gutting Cats?
- 5.3 Headers
- Need help real fast please..
- Stupid Nitrous Question
- Injector numbers.
- quick throttle body question
- Ceramic coating coming off ASM headers
- 6.0L LQ4 is in and Running
- ASM headers and STS kit
- 02 pcm
- Nitrous Question
- 05 fans
- Cam Idle help
- What Performance Club are you In????
- Help, Nitrous Problem!
- Best Head Upgrade on a 4.8?
- Magnaflow SSS 6.0l catback on My 5.3 ext cab k1500
- How much HP does my friend have?
- Who makes turbo kits for trucks?
- radiator
- Looking for 6.0L exhaust flanges
- tranny and oil coolers?
- 8.1L STS help please
- 60 lb injector swap on Radix 2004
- Anyone running B&B exhaust?
- Alright, here's the deal, I need some good old fashioned peer pressure!
- Quick help with 02 Tahoe rough idle & SES light on
- Servo upgrade?
- wasn't expecting pacesetters to look like that
- spark plug analysis
- Chromolyy Driveshaft
- ABS and eBrake lights on "service brakes soon"
- Heading to the track tonight!
- Another New-Guy Question
- cyclinder miss fire problems
- Tune class
- Spark Plug Gap ?s
- new a/c condensor in.....now what? a few questions.
- Whipple / fuel PSI help needed quickly!!
- T56 Swap A Great Success Again
- S&S Tri-Y 24'' headers
- Mods and Milelage??
- Went to Houston Raceway Park tonight...
- First Dyno pull today, WTF-O?
- The Perfect CaM
- MAGNAFLOW muffler ...!!!
- How much for Nelson tune?
- Trouble Posting to Classifieds?
- tuning for ported tb help needed
- 6.0L LQ9 is in and running
- GM FASTEST TRUCK LIST!
- tuff spark plug
- Thorleys? Is this right?
- Radix fuel pressure
- what bolt on mods for a stock truck
- 99/02 pcm swap
- Seeking advice on roller rockers
- Track better than Dyno...new 1/4 mile times
- anyone spinning the mt et streets on the track?
- 1TrueSS T56 Track & Dyno Video
- torque wrench???
- corsa exhaust
- Anybody using MTI B1(221/221 558/558 114) cam
- Which muffler????
- Headgasket question
- Lockers
- 6.0 w/ 4.8 tuning problems
- 6.0L LQ4 / 67 Chevy Pickup 1/4 times
- Need Install Help Fast--radix
- Question about 6.0 swap
- Has anyone actually put a fuel pressure gauge...
- how much grinding to fit 15"s?
- Nelson Tune Questions
- replace muffler only or muffler/pipe?
- tri-y headers for 04
- Silly ?
- can i fit 16x10 or 16x12.5 rims and what backspacing
- Need suggestion for better 60' times.
- Considering 6.0 swap. Hold off on exhaust?
- Problem with my truck @ idle
- 6.0 Kill MPG?
- Run the truck today and...
- motor swap
- Dropping Oil Pressure>??????
- Regency 4.8
- 3/4 ton 6.0 or 1/2 ton 5.3?
- how far can a 4.8/5.3 block be bored?
- Torque: Pushrods vs. OHC
- Another problem with IAC
- little exhaust clip of my truck
- Double online discounts - save up to $500.00!!!
- New Duramax Best
- differential failure
- trailblazer stall?
- Installed Vig 2800 and "check engine oil level" light came on.
- 554 Head Casting on a Truck engine???
- Something for the Radix guys to watch out for...
- pt88 pic's
- bore size of 6.0
- Gauges installed w/ pics & Radix Update
- gates belts...
- z06 cam in 5.3
- Truck owners with odometer MPG readout, a question..
- question on headers
- look what I got
- Need some estimates on 6.0 power please..
- gmc 2003 5.3
- My Impressions on Vig 2800
- What to do with my 4.8 5spd...
|
View Full Version : GM Engine & Exhaust Performance Pages :
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
[68]
69
70
71
72
73
74
75
76
77
78
79
80
81
82
83
84
85
86
87
88
89
90
91
92
93
94
95
96
97
98
99
100
101
102
103
104
105
106
107
108
109
110
111
112
113
114
115
116
117
118
119
120
121
122
123
124
125
126
127
128
129
130
131
|
|
vBulletin® v3.7.4, Copyright ©2000-2010, Jelsoft Enterprises Ltd.