- headers glowing??
- how cold is too cold?
- Cam for my truck
- Jag Perfomance
- 6.0 coming
- Results from installing AFR 205 heads
- Digital Camera For Sale
- ls1 hot cam installed
- HELP - Magnacharger installer in St. Louis?
- Spintech Muffler?
- LS1Edit guys inside
- Aero-Turbine Muffler?
- AMW catch can pics
- Hp Or Ls1 Edit
- Frustrated
- Full Cell
- Denali awd 6.0 Stall question
- Got a LS1 question
- 6.0 question
- injector question
- Hey You Programmer Types
- Belt is Tearing.. and wheres the Idle Screw
- New Exhaust
- Dyno results for Dynatech headers
- Enter here for a chance to win...And current specials!!!
- HPTuner in, ADDED 22* timing!!! And a few other things.
- Vinci Cams
- ls1 edit and hp tuners how to
- HELP? FIPK, Series 77, Airaid or Volant????
- Fuel rails?
- 4.8 heads on a 5.3?
- Cam Install Question
- Need a clutch fast
- GM Truck Turbo Kit - Free Installation
- GM Truck Turbo Kit - Free Installation
- Where to find injector duty cycle in HPT?
- I heard you can't pull heavy loads with a turbo
- Texas Speed 99+ Single Front Mount Turbo Kit Info:-->
- sts owners inside
- 6.0 question
- radix
- upd on vacation or what?
- Heads and cam WERE going in on Friday....now I'm not sure
- Gasket Sets for 5.3 Vortec
- which setup would be best?
- 4.8 or 5.3
- M&H Racemaster 275/55R16 are now available!
- does lowering the truck lower ur time?
- Corsa is on.
- Best price on ASM headers?
- Radix/Eaton Q?
- Tuning decision? Posted in Tuning section also
- Will stock pushrods be OK temporarily ??
- Todd - where's the 500?
- Exhaust Question
- exhaust pressure and big freakin turbos
- Help with SCR and DCE specs for head swap.
- Help with SCR, DCR, and head swap...
- opinions on buying a converter..
- I need a fan shroud
- broken head bolt
- 2001 Hard to start??
- What headers? Long tubes?
- 94 Lightning goes down !
- Service 4x4 light
- Thorley headers for 03 SS?
- what is needed to swap v6 to v8
- Yank TT3200
- Banks Twin Turbo DIY
- headers?
- Advice needed What to buy
- Head bolts
- Trans, Tune, and shifts
- new cam and push rod length
- flexalite fans will they fit?
- Some with a service manual, please help
- Fuel problem
- what causes P1416 code
- EGR removal
- my memory is failing me
- stoker
- can NOT find a regular cab short bed
- Need guidelines for swaping PCM!?
- Recovering PCM with HPT v1.6
- White spark plugs
- What's the single best mod for a 5.3?
- Throttle Bodies
- HELP!!! Damn truck wont stop dieing.
- NGK V Power Plugs good for STS ?!
- Lq4/lq9
- cam ? for 4.8L
- Next Mod?
- Question about convertor breakin?
- Shift points on cammed 5.3
- sugestions on performance parts (4.8 li )
- ls2 tb
- Thoughts on buying a Vortec for my Denali
- mass air
- New crank position sensor in 03+?
- ok got some codes and other findings
- hand porting heads
- Just a dumb newbie question.
- Shorty headers
- New engine is tearing itself apart!!!
- Accelerated Cams?
- What will void my warranty?
- What needs to be done to increase shift point
- Which long tubes for a 99 5.3?
- Still struggling with Stall decision...
- New Cam Is In.
- Will it hold?
- 2001 Tahoe 5.3L ...Help me make horsepower....suggestions please
- catalytic converter
- Which of these converters are best for daily driving?
- STS Turbo installed last night.
- New 2005 Crew/short Chevy Z71
- is this safe or am i making a bomb?
- AMW catch can oil - after 1 week [pic]
- 05 e-fan connectors?
- Intank fuel pump noise?!
- Supercharger!
- Throley Headers are on!
- cam and idleing issues
- How much nitrous will a 5.3 hold
- TC install help
- Ls1 Edit Question
- New tip for removing stock crank pulley
- 8.1 Crew track times, stockish.
- finally got to run today
- Who has broken their 4.8/5.3/6.0L?
- new track times with new cam!!
- Brembo Brake Rotors Group Buy 299.00 Set Of Four Rotors Cross Drilled Slotted !!!
- timeslip from the track meet today
- I need to rebuild my bigblock with one of these!!!!!
- Just got my Nelson tune with track times!
- Anyone have Flashscan?
- 04 1500 Crew Cab Track Times
- 6.0 swap into a 1980 Malibu?
- fuel pump??
- ***Big header/exhaust sale at TBYRNE Motorsports!***
- p0300 help?
- How to Clear SES code P1336 Crankshaft?
- What Type of Oil do U use...
- Stock injector ratings for 03 & 04 6.0 LQ9 engines?
- Which Boost gauge and how to install?
- Intake!
- Turbo stumbled hard under load.
- Vid from the track
- new track time OBS truck
- Gained a Tenth w/ 02 PCM...
- New best! Not by much. (Vid.)
- dumb tuning questions
- does 87tuning do anything on hpp3?
- What's the best rear?
- 160 or 180 T-stat with Radix
- first dyno run
- Cam and gears
- Dyno Jet commander
- superchips question...01 5.3 z71
- Which Has More Benifit
- Newest Track Times
- noob requesting LS1 building help
- H2 Radix install going on today
- ET gains from open to posi or locker?
- 6.0 specs
- 01 tahoe stalling and dieing
- ARP L19 head stud torque
- Dyno #'s at MTI
- e-fan pcm question
- Duramax guys, possible problem or just normal?
- 6.0 swap, any tips?
- Converter Stall
- Radix Update, Tightened Radix Manifold bolts
- Turbo Emissions
- Whats next???
- Nelson or Hp?
- cam comparison
- Advice
- exhaust dilemma
- What did you pay for your Radix or STS?
- dyno
- what all is needed to swap from 4l60e to 80?
- site wont let me post in classifieds?
- ASP Pulley's
- N/A intake mods... are they needed?
- 5700 -5800 rpm = what Mph???
- Tb convertor and tr224
- MSD 8.5 wires
- misfire
- 05+ Silverado brakes
- Intercooler installed, getting closer
- Sts intercooler ideas
- 05 Silverado with aluminum block OHhh YES, 310 HP
- diesel fuel in a gas engine
- Got my TCI SF3000 In!
- 6.0 Swap... Header Purchased....Need Help on Cam!!!
- 6.0 build-up...turbo in the future
- New 1000hp. Truck Fuel Systems Now Available!!!
- Tach output for 04' Silverado
- Finally bought my truck an intake!
- exaust cutout
- Good time? or not?
- What size 15" wheels fit??
- What year 4l80?
- Which mod first???
- oxidizr or Quik03
- H2 Radix install finally complete
- Question on behalf of my dad...
- need new cats
- Looking For The Big Dogs!
- I want a elbow
- Stock 4.8L Silverado (2001)
- eaton supercharger for a 3.8L
- torqconverters
- Any one Ever run at Atmore?
- Dyno vids
- LS1 Fans from wrecking yard
- for the big horsepower truck owners
- Hrp Friday 2-5-05
- mileage in a '01 2500 HD
- Oh no, not another one of these!
- BigKid, hook me up with something
- Dropping my Suburban Need help ?
- 5.7L Maggie fit 5.3L Truck?
- My Trucks, new to the site
- What hp#'s should I put down?
- head swap ls1 on 4.8
- Truck Times
- Which springs 918 or ls6
- Trimming STS wastegate spring?
- Fire in truck and computer dead
- Well im back.
- WTB 99' iron heads
- Cam Specs
- pcm controlled e-fans?
- Hole in stock airbox?
- Any Drag Strips Open in N. Georgia?
- Behavior of this cam.....
- Converter Question (not which one is best)
- Dual Exhaust?
- Flowtech LT Headers
- Tuning 212/218 low lift
- Got the Truck Dyno-Tuned
- Radix guys...
- plug wires!!!!!!!!!!!!!
- VHP/Crane accelerate/quick lift rockers.
- Accelerated lift rockerarms?
- retune with new converter?
- 3000 or 3200 stall?
- Ebay exhaust