- 50/50 or distilled water??
- trans cooler in front of intercooler
- tc78 questions
- TVS2300 Front Inlet/Rear Cog Drive
- Radix pulley change - Torque specs?
- stall converter
- Smoking bad first couple min at start up
- vic intake map.
- FYI, selling my TVS1900
- manifold supporting.
- best turbo setup for the money
- 08 silerado 5.3 engine mods
- what to expect
- how many vic jr. intakes are in here?
- TVS 1900 3.2lb pulley (8-9psi but only reading 5psi?)
- TC78 vs T76?
- Flash stall with stock converter
- 243s and radix
- STS exhaust
- starting a turbo build... need help
- Flex fuel pump....
- ?s about Log Header.
- Heat wrapping turbo manifold!!
- info on superchargers
- Ported Blowers
- Boost Creep Need Help.
- 90mm TB and......
- whipple and boost probelms
- any dropped trucks running low mount trick turbo?
- Made up my mind
- 2007 TrailBlazer SS TVS2300 Videos
- dtc code ?
- question about feed and return lines
- the turbo'd 4.3L
- TVS 2300 = 16.5lbs of boost
- Water Injection Kits aka meth kit
- A/F ratio is dropping in boost
- Budget 5.3L questions....
- need some input on cam decision
- guesstimate on gain?
- TVS Powered 5.3 Having Knock Sensor Issue
- cheap knock off or not?
- What would need to be changed??
- spacer for vic JR..meth and boost ref.
- going thru relays w/ the inline Bosch...
- Is it worth it to add meth with no tuning?????
- Officially joining the Dark side
- Radix 6.0 Exhaust
- Procharged Silverado
- What is the difference
- 4.3 turbo cam
- What wide band to use?
- Anyone make their own manual boost controller?
- 05 Catch Can With Or Without PCV?
- need cam help
- 80?? 88?? for a 408 street truck???
- wynjammer supercharger??
- TVS Quick Change Aluminum RIP Pulley's
- E85 afr
- Weeeeeeeeeeeeeeeeeeee! TVS is fun!
- patriot st2 lq9 on a 00 5.3??
- Cam Question
- super vic jr.
- Anyone had this happen with their tvs 1900?
- meth question
- tvs1900 turning up the boost?
- patriot cam
- ls6 cam, turbo, guys with truck intake
- Radix J-tube accept 90mm cable TB?
- Need more power (pulley?sdtune?
- ...RIP Race Pulley!
- new to the forum Procharger question
- turbo... MAF or speed density?
- New guy with fuel pump question
- ls7 style 60 pound injectors on victor jr.
- I hate cheap parts!!!!!!!
- mp112 from a LQ9
- is this turbo big enough?? what about the A/R??
- New Vortech Twin Screw installed on 5.3 Chevy. Looking for a tuner...
- lets just say...
- Looking for intercooler options
- 6.0 with Magnacharger Boost problem
- 08 GMC Front Mount, custom build
- Turbo rebuild suggestions
- Techco
- procharger 4.8
- Powerdyne on an LQ4?
- Fuel starvation under hard acceleration
- CNC'd L92 heads.... help or hurt???
- front mount turbo vs. magnacharger for DD
- procharged guys
- post up your turbo vids
- TB gasket for wilson elbow
- turbo help
- wiring up a innovate lc1
- Done w/ the Front Single
- MPT70 on 6.0
- Whats the cure for lean #7
- return fuel/vic jr/88mm
- Lingenfelter ASA restricter for Procharger guys
- which 90mm drive by wire tb?
- which forced induction converter?
- Couple of questions on mp90???
- Need help picking out a cam!!!
- Turbo setup
- what will it take for a 5.3
- what would make more power on a blower set-up?
- Front mount intercooler for a 93 fullsize truck
- Whipple Dyno results
- what is needed to support 900rwhp (fuel system)
- Bov OR boost leak???
- i bought a turbo....now my plans just changed..WILL THIS WORK
- Going for big boost on a forged 5.3
- What peak boost number
- HOW TO rebuild a T3/T4 turbo
- meth tuning *timing*
- Ready to boost the 5.3!
- Anybody want anything custom built?
- La Blue Sneak Peak
- TVS 1900 + 6.0=performance?????
- Piston #7 carnage pics
- what piston rings to run???
- got some times today
- anyone using the super victor w/fi
- cablebandit reaches goal of 9.3x...on DR's!
- switched from supercharged to turbo
- How much boos/power have you made with ur 5.3?
- Cobalt map sensor
- Best exhaust setup with magnacharger
- Procharger Fuel System Question....
- Sharadon Performance Build (Supersub has competition)
- A few turbo 5.3 questions
- New Truck Guy
- MP122 and a few questions.
- capable of 10's?
- Dash removal
- How much power will the stock fuel pump support?
- Gears for Forced Induction?
- mp t-76 vs. Turbonetics T-76
- Wastegate setup for procharger setups
- supercharger exhaust
- Updated pics of Turbo Built
- What kind of heads on my turbo 5.3
- 2300 TVS supercharger
- TVS 1900 smaller pulley?
- good cam for fi
- wiring harns. with vic.jr and turbo
- Front mount turbo, 8.1L
- tvs on sbc
- Headgasket blown??
- HELP 343hp/359torque 6.0 Supercharged WTF!
- 228/222 .588/.581 115lsa what ya think *turbo*
- weak ass hemi
- post up you turbo pics
- Silicone couplers
- Ls6 vs custom cam *turbo*
- Need a nice turbo kit built. Any takers??
- 5.3 Turbo, what mods.
- Well 4.8 wasted after 20psi boost creep.
- Question about turbo fuel injectors?
- well sold the 78mm...looking for a new turbo *need advice*
- So is turbonetics turbos junk?
- stock 6.0 @12psi
- 12's it is!!!! WOOT
- LT's plus rear mount (sts)
- Post up turbo videos!!
- Post up turbo videos!!
- 4.8 Pulled Apart
- boost problem
- What size pulley for MP112?
- Is there a difference between the truck 6.0 and the truck 6.2 exhaust manifold?
- Killer Chiller Installed
- intake solution
- spek boost controller?
- Turbo tuning
- GM 2 bar map sensor PN?
- SC a high mileage 5.3?
- What wall thickness for Log Front Mount?
- Converter stall speed vs spool up
- quick question for those who have built their own turbo kits
- Motor Time, opinions and help appreciated
- Thoughts of Upping the boost?
- what can you tell me about the diferent magnas for an 03 ss?
- First dyno numbers on nnbs
- Just bought a RST silverado and ordered a Maggie 112
- First time at the track with whipple.
- Pistons...
- Remote turbo return filter
- Blow through MAF
- Whipple on a 4.8 question?
- Who uses 3.3" pulley on their magnachager?
- No Wastegate flutter / Release
- Valve springs on 5.3 W/ZO6 cam and MP122HH???
- What kind of RWHP?
- building I/C sprayer
- decisions decisions... need some help from the pro's
- Relocating IAT
- Spark plugs?
- MP112 LQ9 Pulley Size
- F1A procharger build has begun
- Bosch 044 install
- Vortech supercharger
- HELP Intercooler Gash
- Stupid Question need alittle help
- She's Alive
- finally got the cam installed **video**
- Magnacharger knocking noise at low RPM??
- What belt size with 3.3" pulley?
- instructions for TVS 2300 with jacksaft??
- Turbo Cam....
- how much boost to meet my goals?
- Who has the best price on Stainless Steel Tubing?
- Radix fuel rail
- 60lb injectors on a TVS1900 ???
- Alcohol and water in intercooler
- lets talk fuel setups.
- maggie 00 to 04?
- supercharger exhaust
- Dynoed my Whipple Denali again
- Meth Injection
- need head gasket advice
- turbo+stick...come in
- 255 vs bosch 044
- Maggie and cooler weather.
- Magnacharger Slop
- 95 4.3 and Eaton from 3800 possible?
- how did everyone route their oil lines
- What do you guys think of this cam
- 370 W/S475 Getting started
- daily driver with a Maggie
- 6.0, mp 70 - swapped to 1.32ar
- What % Meth Mix do you Magie guys use?
- New MSC front mount turbo almost done!
- 18psi on 408 dyno #
- gotta question
- turbo 4.3 sonoma project.
- What rings you guys making over 12 psi running
- STS intake help.
- More upgrades for the Supersub!
- fuel sytem limitations?
- sts fuel system prob
- Whipple supercharger
- Who has tuned a FM turbo 5.3 with 01 ZO6 cam and 317 heads?
- arp studs for my turbo build?
- aFe stage 1 install.
- meth on a whipple? where to spray?
- Whipple's New Intercooled Chevy Kit Now Shipping
- Radix idler pulleys out of alignment
- my meth problem
- Intercooler question