2002 Yukon XL Dyno runs
#1
2002 Yukon XL Dyno runs
Here's the pulls form the Dyno this weekend. Test we done at Simon CPR in Richfield WI.
Truck is a 2002 Yukon XL 2500, 8.1, 3:73 gears, 33" tire. Motor is .02 over, Raylar BP202 cam, 1/2 completed modified stock airbox, and a Blackbear tune. Rest is stock.
Runs were done is 3rd gear. It liked it better when he rolled into it rather than punch it. I have EFI logs of the runs also if anyone wants to see them.
I have SW long tube to put on next with new mufflers and dual tailpipes. Will test again after that to see gains.
Truck is a 2002 Yukon XL 2500, 8.1, 3:73 gears, 33" tire. Motor is .02 over, Raylar BP202 cam, 1/2 completed modified stock airbox, and a Blackbear tune. Rest is stock.
Runs were done is 3rd gear. It liked it better when he rolled into it rather than punch it. I have EFI logs of the runs also if anyone wants to see them.
I have SW long tube to put on next with new mufflers and dual tailpipes. Will test again after that to see gains.
#2
#3
This is all great info! Now only the stock iron heads are whats holding you back from pulling to 6000
Was the vehicle tuned with the cam or raw for the first round of tuning? Do you have a modified intake manifold yet?
Was the vehicle tuned with the cam or raw for the first round of tuning? Do you have a modified intake manifold yet?
Last edited by Raylar Engineering; 04-13-2016 at 03:30 PM.
#4
Yes. It was Blackbear tuned and had your cam in it when it pulled the 282/351 numbers. Also a cold air intake. Wish I would have got a stock baseline.
Thread
Thread Starter
Forum
Replies
Last Post
03regcab sierra
Dynamometer Results & Comparisons
20
08-03-2015 12:11 AM
bsgiffor
GMT 800 & Older GM General Discussion
1
07-19-2015 11:14 AM